Beacon Simulator BG-105

BG-105 in operation

Technical description

Operational Modes

Up to five independent Beacons (Channels) transmitted simultaneously.  Operational Modes is as follows:

-   Continuous Wave (CW) 
-   Continuous Message (CM) 
-   Burst – deterministic repetition period
-   Burst – random repetition period
-   Burst – External Triggered
-   Burst – Manual Triggered

Individual Beacon-Transmitter Parameters:

Digital Message Generator
-  Repetition Period: 0,5…65 s, Resolution - 0,001 s
-  Relative Message Offset: 0…16 s, Resolution - 0,1 s
-  Total Time Transmission: 435.6…444.4 ms and 514.8…525.2 ms, Resolution - 0,1 ms
-  Unmodulated Carrier Time: 158.4…161.6 ms, Resolution - 0,1 ms
-  Bit Rate: 400bps ±1%

Modulator and 406 MHz Transmitter
- Frequency: 406.000000…406.100000 MHz, Resolution - better than 1 Hz
- Frq. short temperature variation: better than 2*E-09   (2 ppb)
- Frq. mean slope: better than 1*E-09   (1 ppb)
- Residual frequency variation: better than 3*E-09   (3 ppb)
- RF Output signal attenuation: 0…45 dB (0…85.5 dB max), Resolution  - 0.5 dB
- Phase Deviation: 0.9…1.3 rad, Resolution - 0.1 rad
- Modulation Rise/Fall Time: 50…250 us, Resolution: 1 us
- Modulation symmetry: ≤ 0.05
- Burst-switch attenuation: ≥ 45 dB

RF Output
Output Connector:     SMA Female
Power Level (when 5 simultaneous beacons at max power):         0dBm ±1dB
Output Impedance:    50 Ω
VSWR:           <1.3

Safety and EMC
Safety class:                                      I (EN61010-1)
EMC:                                                 Complies with EN61326   Class B.

Power Supply
Power supply:                                    115/230V ± 10%, 50/60 ±3 Hz
Power consumption:                          <10 W

Operating environmental conditions
Operating temperature:                     +5°C…+40°C
Storage temperature:                        -20°C…+40°C
Max. rel. humidity:                             40%...60% (non condensing)

Transport and storage environmental conditions
Temperature:                                     -40°C to +60°C
Humidity:                                           5% to 95% (non-condensing)
Pressure:                                           equivalent up to 15km altitude

Mechanical
Dimensions (W x H x D):                  485 x 132 x 405 (mm) 
Weight:                                               8 kg

 

Products

406 MHz ELT Tester (Test Set)

406 MHz / 243 MHz / 121.5 MHz ELT TESTER is designed to check the avionics emergency locator transmitters (ELT) operating via COSPAS-SARSAT system. It provides accurate testing in volume of annual or maintenance requirements or fast check after ELT's encoding or installation in accordance with USA (FAA Part 91.207), Canada (CAR 571 Appendix G), Europe (CAA/EuroCAE) requirements.

ELT Tester Mini w/ Wi-Fi

ELT Tester Mini w/ W-Fi is third generation device designed to check the avionics emergency locator transmitters (ELT) operating via COSPAS-SARSAT system. Tester is operating with any mobile phone or desktop PC by means of Wi-Fi connection. It is small and light-weight. The ELT tester provides demodulation and complete decoding of Cospas-Sarsat messages. Test results will be displayed in your mobile phone, tablet or PC. All tests will be stored in internal memory for future use.

BT-611M Beacon Tester

BT-611M Beacon Tester is designed for high accuracy and resolution measurements of the full set of beacon signal parameters to check its compliance with the ones, specified in C/S doc. T.001, T.007. The tester is succesfully used for Cospas-Sarsat type approval certification process. It is professional specified test equipment for beacon manufacturers or test laboratories, service centers.

Airborne AIS Test Set

Airborne AIS Test Set provide reliable testing of Airborne/Aircraft Automatic Identification System operation. The AIS Test Set is intended for verification of marine and avionics AIS installations. The AIS Tester is specified equipment for radio surveyors, classification societies and administrative authorities. AIS Tester allows to test all type of AIS transponders of any manufacturer.

Sarsat Beacon Monitoring System

Cospas-Sarsat Distress Signal Homer Receiver is specially designed for 406MHz emergency radio beacon signals detection, reception, verifying, decoding and positioning. It is a wide range ground/mobile real-time COSPAS-SARSAT signal decoder designed to locate and verify emergency distress signals sent by any 406MHz ELT in local search area.

Aircraft Radio Test Set

The Aircraft Radio Test Set enables functional and verification testing of MF/HF/VHF airborne radio equipment, emergency locator transmitters as well as airborne AIS stations. Aircraft Radio Test Set is be used to diagnose faulty radio communications equipment while installed in the aircraft. Set fulfills the specific requirements for maintenance, repair and device verification after production.

AIS (AIS-SART) Tester Pro Lab

AIS (AIS-SART) Tester Pro Lab is designed for laboratories and manufactures of AIS and AIS-SARTs. The AIS Test Set is intended for verification AIS and AIS-SART parameters in real time with saving all received data. AIS Tester Pro Lab is extended version of AIS Tester M1, have the same features but allows to perform deep analysis of AIS and AIS-SART functions in real time.