406 MHz ELT Tester (Test Set)

ELT Tester connected to laptop

Connection to PC or laptop

After all tests are done usually it is required to process the measured data, prepare and print the test reports.

Thus the ETL Tester (Test set) can be easily connected to any PC or laptop. The connection is carried out by means of standard USB A-USB A cable and special software available on this website. The minimal requirements are Microsoft OS, such as Windows XP, Windows Vista or Windows 7 and at least 1 USB port. No special hardware configuration is required.

Also the special FTDI driver should be installed for proper connection. It can be downloaded at our web-site as well.

So, it is very simple to connect the tester to PC. Connect one side of the cable to tester and other to PC. Then install the drivers following the standard Windows wizard. After the driver is installed run the software. No installation is required. Just run the executive file and press DOWNLOAD MESSAGE button. All measured data will be transferred to PC.

 

Products

ELT Tester Mini w/ Wi-Fi

ELT Tester Mini w/ W-Fi is third generation device designed to check the avionics emergency locator transmitters (ELT) operating via COSPAS-SARSAT system. Tester is operating with any mobile phone or desktop PC by means of Wi-Fi connection. It is small and light-weight. The ELT tester provides demodulation and complete decoding of Cospas-Sarsat messages. Test results will be displayed in your mobile phone, tablet or PC. All tests will be stored in internal memory for future use.

BT-611M Beacon Tester

BT-611M Beacon Tester is designed for high accuracy and resolution measurements of the full set of beacon signal parameters to check its compliance with the ones, specified in C/S doc. T.001, T.007. The tester is succesfully used for Cospas-Sarsat type approval certification process. It is professional specified test equipment for beacon manufacturers or test laboratories, service centers.

Beacon Simulator BG-105

Beacon Simulator BG-105 is high-precision simulator of Cospas-Sarsat emergency beacon messages. BG-105 allows to simulate up to five simultaneously operating beacons with messages overlay in time. The generator is intended to operate under PC control to provide the customization of main parameters of each simulated beacon on every of five channels by means of terminal program.

Airborne AIS Test Set

Airborne AIS Test Set provide reliable testing of Airborne/Aircraft Automatic Identification System operation. The AIS Test Set is intended for verification of marine and avionics AIS installations. The AIS Tester is specified equipment for radio surveyors, classification societies and administrative authorities. AIS Tester allows to test all type of AIS transponders of any manufacturer.

Sarsat Beacon Monitoring System

Cospas-Sarsat Distress Signal Homer Receiver is specially designed for 406MHz emergency radio beacon signals detection, reception, verifying, decoding and positioning. It is a wide range ground/mobile real-time COSPAS-SARSAT signal decoder designed to locate and verify emergency distress signals sent by any 406MHz ELT in local search area.

Aircraft Radio Test Set

The Aircraft Radio Test Set enables functional and verification testing of MF/HF/VHF airborne radio equipment, emergency locator transmitters as well as airborne AIS stations. Aircraft Radio Test Set is be used to diagnose faulty radio communications equipment while installed in the aircraft. Set fulfills the specific requirements for maintenance, repair and device verification after production.

AIS (AIS-SART) Tester Pro Lab

AIS (AIS-SART) Tester Pro Lab is designed for laboratories and manufactures of AIS and AIS-SARTs. The AIS Test Set is intended for verification AIS and AIS-SART parameters in real time with saving all received data. AIS Tester Pro Lab is extended version of AIS Tester M1, have the same features but allows to perform deep analysis of AIS and AIS-SART functions in real time.